Shooting Shed Products

Scope Alignment System (Medium) 6mm-11,5mm

Type:

Quantity: - +
Enter your post code for shipping cost.
Calculate

International customers please contact us for price and shipping

Price TBA

Product Description

The original SHED Scope Levelling System (Medium)

Machined from 6082 T6 aluminium hard black anodised and finished with the Shooting SHED logo laser etched both sides. These will maintain parallel to better than 0,01mm (Half a thou!) across the range.

At long last you can take the guess work out of setting your scope parallel to the scope rail with this affordable and easy gauging tool which enables rapid setup in seconds.

Simply slacken the screws off slightly so the tube can rotate in the rings with some resistance, slide the wedges into place with finger and thumb and squeeze them whilst rocking the tube, once the tube stops rocking nip the screws up very slightly, remove the wedges and torque the rings down, check once more by pushing the wedges back in and hold them up to the light.

Gap range 6mm-11,5mm, this levelling system will work with all flat based rifle scopes including Nightforce that are bolted to a common rail, the system will work with flat bottomed scopes over a round receiver as long as the top of the receiver goes over centre. It will not work with open top receivers.

Small image is to show the operation only, these wedges are black, medium height

© Copyright 2017 Actionclear Modern Rifles | Privacy, Disclaimer | Design: Interweb, Web Design Perth | Powered: Australia Domain NamesInterweb